Fascination About bar178 link alternatif

Fascination About bar178 link alternatif

Blog Article

(ii) In utilizing the “extension underneath load” approach, the total pressure (or “extension under load”) similar to the pressure at which the 0.two % long lasting strain takes place may be decided with adequate accuracy by calculating the elastic extension with the gauge length beneath acceptable load and including thereto 0.

(iii) The minimum amount check tension have to be managed no less than 30 seconds and sufficiently for a longer period to make certain comprehensive expansion. Any inside pressure used after warmth-cure and prior to the Formal examination might not exceed 90 p.c from the check tension.

Marking on Just about every container by stamping plainly and permanently are only authorized where by the steel is a minimum of 0.09 inch thick, or on a metallic nameplate permanently secured towards the container by indicates besides tender solder, or by indicates that could not decrease the wall thickness.

A root bend exam specimen should be faraway from the cylinder or welded examination plate that was used for the tensile exam laid out in paragraph (l)(1) of this section. The specimen has to be taken from throughout the circumferential seam and must be organized and tested in conformance with and should meet the necessities of CGA C-three.

(1) No defect is permitted that is likely to weaken the concluded cylinder appreciably. A reasonably smooth and uniform floor is needed.

At or before the time of shipping towards the purchaser, the cylinder manufacturer will need to have all finished certification paperwork mentioned in CGA C-11. The producer of your cylinders should retain the studies required by this subpart for 15 a long time from the original exam date in the cylinder.

This examination may be utilised and should be as necessary by CGA C-3. The specimen have to be bent until the elongation in the outer surface, adjacent to the root of the here weld, in between the frivolously scribed gauge lines a to b, has to be at the least 20 p.c, other than that this percentage may very well be minimized for steels getting a tensile toughness in extra of 50,000 psig, as furnished in paragraph (k) of this segment.

(two) All seams with the sphere or cylinders need to be fusion welded. Seams need to be from the butt or joggle butt style and signifies should be provided for accomplishing finish penetration of the joint.

Materials should be identified by any appropriate process, apart from that plates and billets For decent-drawn cylinders needs to be marked with the heat range.

Reheat treatment is authorized for turned down cylinders. However, Each and every reheat handled cylinder need to subsequently pass all of the prescribed checks. Repair by welding will not be licensed.

All spun cylinders and plugged cylinders needs to be examined for leakage by gasoline or air stress soon after the bottom has long been cleaned and it is absolutely free from all dampness issue to the following circumstances and restrictions:

Previous to any test, all cylinders need to be subjected to an answer warmth therapy and ageing treatment method suitable for the aluminum alloy employed.

(3) A plugged cylinder is a single by which a long lasting closure in the bottom of the completed cylinder has been effected by a plug.

(iii) If the measurement of the cylinder does not permit securing straight specimens, the specimens can be taken in almost any area or way and should be straightened or flattened cold, by tension only, not by blows.